Ohm Selector with Slave Out & Depth Mod
The yellow wire running from the 5K Linear Pot to the 8 ohm tap does have a 47k resistor spliced into it. It is encased in the red shrink tubing.
This will produce
a signal with one tenth of the voltage on the 8 ohm tap if the slave level is turned all the way up.
At full power this would be about 3 volts maximum and you can
of course turn it
down as low as zero. You can use the slave out to feed another power amp or for direct recording or PA use.
You must always have
a speaker connected. You can run a cord from the slave out to a processor and then to a stereo power amp and two cabinets. This way you will have a dry cabinet
connected to the amp itself and a stereo pair of wet cabinets with the processed sound.
